Juice Charger Me
EV charger by Juice. Compatibility with energy supplier apps, Home Assistant and evcc.
At a glance
| Device type | EV charger [evcc template, 2026-10-19] |
|---|---|
| evcc support | Yes |
| Connection | Modbus TCP (inferred from evcc template parameters) [evcc template, 2026-10-19] |
| Local control (no cloud) | Yes via evcc's connection type [evcc template, 2026-10-19] |
| Home Assistant | Unknown know this? tell us (brand not yet checked) |
| Known firmware notes | The 'Modbus TCP Server' must be enabled. The setting 'Register Address Set' must NOT be set to 'Phoenix' or 'TQ-DM100'. Use the third selection labeled 'Ebee', 'Bender', 'MENNEKES' etc. Set 'Allow UID Disclose' to On.
Firmware 5.33 or higher is required for phase switching (if supported by the model). The 'SEMP interface' must be enabled, the 'SEMP Charging Mode' must be set to 'Surplus Charging'. Set 'Software function to use phase switching' to SEMP.
For charging stations with two charging points (e.g. AMEDIO, Twincharge), each charging point must be configured separately. Set charging point 1 to Port 502 and charging point 2 to Port 503. [evcc template, 2026-10-19] |
Energy supplier apps
Supplier lists are published per brand (sometimes with model conditions). A brand match does not guarantee your exact model works — check the linked page or the supplier's app.
| Supplier / service | Status for Juice charger | Source |
|---|---|---|
| Frank Energie | Not listed Juice is not on Frank Energie's EV-charger list | [source, 2026-10-19] |
| Tibber | Not listed Juice is not on Tibber's EV-charger list | [source, 2026-10-19] |
| Zonneplan | Not listed Zonneplan only lists its own hardware | [source, 2026-10-19] |
| Eneco | Unknown know this? tell us | — |
| ANWB Energie | Unknown know this? tell us | — |
| Vattenfall | Unknown know this? tell us | — |
Home Assistant integrations for Juice
Unknown know this? tell us — we have not yet checked Home Assistant support for Juice.
evcc details
| Template | bender-cc (charger) [source, 2026-10-19] |
|---|---|
| Connection | Modbus TCP (inferred) |
| Capabilities | rfiddim [source, 2026-10-19] |
| Requirements | The 'Modbus TCP Server' must be enabled. The setting 'Register Address Set' must NOT be set to 'Phoenix' or 'TQ-DM100'. Use the third selection labeled 'Ebee', 'Bender', 'MENNEKES' etc. Set 'Allow UID Disclose' to On.
Firmware 5.33 or higher is required for phase switching (if supported by the model). The 'SEMP interface' must be enabled, the 'SEMP Charging Mode' must be set to 'Surplus Charging'. Set 'Software function to use phase switching' to SEMP.
For charging stations with two charging points (e.g. AMEDIO, Twincharge), each charging point must be configured separately. Set charging point 1 to Port 502 and charging point 2 to Port 503. [source, 2026-10-19]evcc sponsor token required |
| Known caveats | None listed in the evcc template. |
“Works for me” reports
No user reports yet. Report your firmware version and setup TODO: form
Where to buy
Shop links will appear here. TODO: affiliate placeholder — no links yet See our affiliate disclosure.